Fixing Cracks In Concrete Floor



Learn how to fix minor cracks in concrete with a patch and find out when replacement is necessary

Best Fast Drying Crack Filler Dap 37584 Liquid Cement Crack Filler. This liquid cement or concrete crack filler is ideal for narrow cracks on the. PC-Concrete Two-Part Epoxy Adhesive Paste for Crack Repair. PC Concrete is a well-known name in this industry. Bluestar Flexible Concrete Crack. As the concrete shrinks, it will slowly begin to form hairline cracks. Hairline cracks are normal and do not affect the integrity of the concrete. Often contractors might add a little too much water to the mix to make it easier for them to apply.

Cracks between 1/8 and ¼ of an inch often result from house settling or concrete shrinking within a few months after construction, and so may pose no structural problem. But it’s a good idea to. Fill the Crack with Patching Mix (also know as Vinyl Concrete) Patching mix is made from vinyl, Portland cement and sand. It covers cracks up to 1⁄2 inch wide. Dampen the area around the crack, and then trowel on the mix.

If your driveway, patio or other concrete surface has cracks, they can often be repaired. In some cases concrete crack repair can be a simple DIY project, in others it may require a professional concrete contractor to correct the damage and in the most extreme cases your concrete may need to be removed and replaced.

Find a concrete contractor near me.

Find crack repair products.

REPAIRING SMALL CRACKS

For minor cracking, here's how to fill cracks in concrete with a concrete patch or crack filler:

1. Chisel out the crack to create a backward-angled cut, using a cold chisel and a hammer.

Fixing

2. Clean loose material from the crack using a wire brush, or a portable drill with a wire wheel attachment.

3. Apply at thin layer of bonding adhesive to the entire repair area using a paint brush. The bonding adhesive helps keep the repair material from loosening or popping out of the crack.

4. Mix vinyl reinforced patching compound, and trowel it into the crack. 'Feather' the repair with a trowel, so it is even with the surrounding surface.

Wide crack variation

If the width of the crack is an inch wide or larger, the process of repairing cracks is slightly different. Chisel out the crack and clean loose material as listed above. Then pour sand into the crack within the surface. Prepare sand- mix concrete, adding a concrete fortifier, then trowel the mixture into the crack. Feather until even with the surrounding surface.

Tip: If you don't like the way your repairs look, consider concrete resurfacing for a fresh, uniform surface.


Concrete Patch & Repair CompoundsLATICRETE® concrete surface patch and repair products
Concrete Patch and RepairHigh-performance, multi-use, fast-setting
Levelflor® by Rapid SetFor indoor & outdoor use. Excellent for repair projects.
Fast Patch - Concrete RepairSimply mix with water and trowel

HOW TO TIPS FOR FIXING CRACKS

Repairing and resurfacing driveways: Step-by-step guide

IS IT WORTH FIXING, OR SHOULD IT BE REPLACED?

Fixing Cracks In Stained Concrete Floors

Fixing

Concrete that is cracked only on the surface, or has hairline cracks where both sides of the crack are still level can be successfully fixed. See basics of concrete repair and troubleshooting

Cracked concrete should be replaced if due to the three conditions listed below. Any patching material used to fill these types of cracks will only be a short term fix. You definitely would not want to patch these cracks and then spend money resurfacing the concrete or doing a decorative topping.

Widespread, deep cracks, settlement has occurred

When concrete is cracked all the way through the slab it should be replaced. Sometimes this is due to the weight of large trucks, improper preparation of sub grade, erosion of sub grade, or other reasons.

  • Remove the concrete
  • Remove the sub grade
  • Replace sub grade with compactable material (sometimes existing material is ok)
  • Compact the sub grade
  • Pour back concrete

Sunken concrete

Sunken concrete occurs when the sub grade was not prepared properly. Loose dirt may have been used for the sub grade. When this dirt settles-sometimes due to sprinkler or rain water going under the concrete- the concrete is unsupported and will be more susceptible to sinking.

It is possible that the sub grade was compacted and the concrete was subjected to extreme weight which caused the concrete to sink. This can often we fixed with special equipment that raises the concrete without damaging the slab (HMI Concrete Lifting & Raising Equipment).

  • Remove the concrete
  • Remove the sub grade
  • Replace sub grade with compactable material (sometimes existing material is ok)
  • Compact the sub grade
  • Pour back concrete

Frost Heave

Floor

Frost heave is very common in cold climates. Moisture in the ground freezes and the concrete pushes upward.

Fix

Filling Cracks In Concrete Floor Before Painting

  • Remove the concrete
  • Remove the sub grade
  • Replace sub grade with compactable material (sometimes existing material is ok)
  • Compact the sub grade
  • Pour back concrete
Best

Get the advice of a local soils engineer on sub grade preparation for your area and material needed to prepare sub grade (sometimes existing material is ok)

Whether you do the job yourself or contract it done-these are the steps to follow. See what is concrete and ordering concrete for information on ordering the right type of concrete

Fixing Cracks In Concrete Floor Before Tiling


Other Resources: